Choose any of these login options:

Huawei AR1220 VS Huawei AR1220F

The Huawei router AR1220 and AR1220F can be applied to Small branch, managed CPE-Desktop, Rack-mountable-modular.
 
The difference between the Huawei router AR1220 and AR1220F

  AR1220 Routers AR1220F Routers
WAN speed with services 200 Mbps 400Mbps
Flash(default/max) 256 MB 512 MB
Session Initiation Protocol (SIP) No Yes
Conference call No Yes
Branch Exchange for Survivable Telephony(BEST) No Yes
Session border controller(SBC) No Yes
 
The common points between the Huawei router AR1220 and AR1220F
Parameters Router AR1220 and AR1220F
Device switching capacity ...  Read More

share on: Share it! Tweet it! Stumble it! Digg it! Email it!  |  Permalink  |  lookafterpp in Cisco router | 5 Comments

How to Configure IPv6 BGP as using Link-Local Address

IPv6 - Internet Protocol version 6 is the latest version of the Internet Protocol (IP), the communications protocol that provides an identification and location system for computers on networks and routes traffic across the Internet. Today, IPv6 is no longer a novelty, but a reality, and all the Services Providers already think in how to enable IPv6, and also how to provide services using IPv6, and this generates many discussions and mainly a series of tests, which are all very important.
 
Configuring IPv6 BGP as using Link-Local Address
The document represents a configuration example of IPv6 Multiprotocol BGP peering between two 1941 routers using Link Local Address. Each router's active interface (here Serial 0/0) is configured with a unique link local address by command "ipv6 address {ipv6 address} link-local".
...  Read More

share on: Share it! Tweet it! Stumble it! Digg it! Email it!  |  Permalink  |  lookafterpp in Cisco router | 5 Comments

How to Reset the Console Password on the Cisco Router

Question: I'm trying to require a password to be entered (i.e. cisco) when getting into the router and before even getting to the 'user exec mode' prompt.
It would seem that after I set the password 'cisco' and then run the command 'login' in order for the password to be required when getting into the router I shouldn't get the error '% Incomplete command.' and that's why when I currently console in to the router I go immediately to the 'user exec mode' prompt i.e. in my case:
r2
 
Router(config)#line console 0
Router(config-line)#password cisco
Router(config-line)#login
% Incomplete command.
 
The solution:
Added the lines:
aaa authentication login default local
aaa authorization exec default local
 
as described....
 
...  Read More

share on: Share it! Tweet it! Stumble it! Digg it! Email it!  |  Permalink  |  lookafterpp in Cisco router | 9 Comments
lookafterpp
Reputation: 0 (0%)
Member Since:  Jul 2013
Last activity: 5/13/15, 6:05 pm